PC system bus adapter 2173 / 2177
L
5PC system bus adapter EN 1.1
4 Software installation
A driver has to be installed to ensure that the system bus adapter can be recognised by the operating
system.
• The following section describes the installation of the drivers required for the individual system
bus adapters.
4.1 Driver installation
Note!
Windows NT/2000/XP requires administrator rights for installing the drivers!
4.1.1 PC system bus adapter 2173
The driver required fo r PC syst e m bus adapter 2173 is part of the L enze to o ls.
It is automatically installed when the corresponding Lenze tools are installed o r can be manually
selected for installation.
You need not install any additional software for the system bus adapter.
4.1.2 PC system bus adapter 2177
The driver required fo r PC syst e m bus adapter 2177 is part of the L enze to o ls.
It is automatically installed when the corresponding Lenze tools are installed o r can be manually
selected for installation.
Note!
The installation program of the following Lenze tools does not yet include the driver required for PC
system bus adapter 2177. A separate driver update has to be installed here:
• Drive Server 1.0
• Global Drive Control 4.4
• Global Drive Loader 1.0
• Global Drive PLC Developer Studio 1.4
The driver updates can be found at the Lenze homepage in the Internet:
http ://www.Lenze.de
W Downloads W Update versions
Please proceed as follows:
1. Download the driver update from the Lenze homepage to your local hard disk.
(File ”UPDATE_CAN_DRIVER.EXE”)
2. Install the Lenze tools you want to communicate via the system bus adapter.
3. Select the file ”UPDATE_CAN_DRIVER.EXE” to install the driver update.
4. Follow the instructions of the installation program.
Windows 98/Me/2000
When the system bus adapter is plugged into a free USB port the new hardware will be automatically
recognised and the required driver will be loaded.
To Next Page
Loading...