Need help?Do you have a question about the Lenze 8300 Series and is the answer not in the manual?
General| Protection Class | IP20 |
|---|---|
| Output Voltage | 0 V to Input Voltage |
| Communication Interfaces | CANopen, PROFIBUS, Ethernet, RS485 |
| Protection | Overcurrent, Overvoltage, Undervoltage, Short Circuit, Ground Fault, Overtemperature |
| Ambient Temperature | -10 to +50 °C (14 to 122 °F) (derating may apply above 40°C) |
Details on connecting the mains and motor to the inverter unit.
Sets the operating mode for control functions via terminals or the operating terminal.
Loads factory settings or predefined parameter sets into the inverter.
Saves current parameter settings to non-volatile memory.
Applies voltage to terminal 17 (RFR) to enable controller operation.
Defines motor speed via frequency set-point, either analog or digital.
Guides through changing parameters using the code and parameter levels.
Monitors undervoltage, overvoltage, and electronic supply status.
To Next Page
