Need help?Do you have a question about the Lenze 8300-A Series and is the answer not in the manual?
General| Brand | Lenze |
|---|---|
| Model | 8300-A Series |
| Category | Inverter Drive |
| Language | English |
Details PLC compatible inputs, PTC input, TRIP inputs, and various output signals.
Specifies the RS232 serial communication interface for parameter access.
Lists load capacity, input resistance, input levels, and ambient temperature range.
Details terminals for GND, +15V, and 8.2V supply for pulse encoders.
Describes analog input for tachos/setpoints and digital inputs like PTC and JOG.
Groups JOG inputs, external TRIP, reset, and additional Ti time input terminals.
Details frequency input via single-track pulse encoder or master frequency provision.
Explains logic for Qmin, fset/factual, ready status, and pulse inhibit outputs.
Details the analog frequency output characteristic based on Nmax for series 8300 and 640.
Wiring diagram for internal supply voltage, not suitable for PLC applications.
Wiring diagram for external supply voltage, suitable for PLC applications.
Sets operating mode via keyboard/serial interface and general configuration options.
Details settings for controlled and speed-controlled operations using various feedback types.
Configures inverter address, min frequency, encoder type, and encoder constant.
Covers tacho adjustment, JOG function selection, and associated parameters.
Adjusts speed controller gain, time constants, influence, and acceleration/deceleration times.
Selects terminals, converts levels, and configures surveillance functions for monitoring.
Details the procedure for adjusting the speed controller with an AC tacho and diode threshold.
Describes adjustment for DC tacho feedback and speed control using incremental encoders.
Defines code sets, access levels, operating modes, and parameter set loading procedures.
Manages parameter saving, switch-on display settings, and initialisation procedures.
Sets general configuration options and specific operation types like controlled or speed-controlled.
Configures inverter address, min/max frequency limits, U/f curves, and voltage boost.
Sets encoder constants, tacho adjustment values, and JOG selection parameters.
Controls controller release status and the motor's rotation direction (CW/CCW).
Configures JOG function activation and the frequency set value for operation.
Displays actual frequency, motor voltage, and defines fault indication logic for various faults.
Manages fault memory, surveillance signals, and sets the number of pole pairs for motor control.
Defines the password for parameter access and displays the current software version.
Configures additional acceleration/deceleration times, terminal selection, and level conversion.
Selects surveillance signals like external TRIP or PTC motor protection for monitoring.
To Next Page
