Lenze 8300 Series User Manual

EK32/Li 22.03.90 NB 33.1095 D/GB
Seitc/page: 5
3.2 Steuerbaugruppe
3.2 Control stage
a) mit externer 24V—Versorgung
Bild/Figure 5
flsoLl RFR R/L TRIP
flset CW/CCW
a) with external 24V supply
ReLaisiretays 1?;
R1 ~ 600 £2
z.B. Art. Nr.
326 850
e.g. part na.
Digitaler Ausgang
Fehler (umschalt -
bar low—high -
aktiv)
Digitale Eingänge
(aktiv bei
13.. .+30V)
Reclits -/Linkslauf
Reglerfreigabe
Analoger Sollwert
a) Potentiometer
b) Leitspannung
0.. .10V
c) Leitstrom
0.. .2OmA
4.. .2OmA
siehe Beipa~;.
b) ohne externe 24V—Versorgung
Bild/Figure 6
Digital output
Fault (change—over
to low—high—active)
Digital inputs
~ctive with volt -
age levels 13V-30V)
CW/CCW rotation
controller release
Analog set—value
a) Potentiometer
b) Master voltage
0...1OV
c) Master current
0...2OmA
4...2OmA
see accessory kit
b) without external 24V supply
Re1ais/re~ays 15V
R1 ~ 600 £2
~soII RFR R/L TRIP Z.B. Art. Nr. 326 850
~set CWICCW e.g. part na.

Lenze 8300 Series Specifications

General

Protection Class	IP20
Output Voltage	0 V to Input Voltage
Communication Interfaces	CANopen, PROFIBUS, Ethernet, RS485
Protection	Overcurrent, Overvoltage, Undervoltage, Short Circuit, Ground Fault, Overtemperature
Ambient Temperature	-10 to +50 °C (14 to 122 °F) (derating may apply above 40°C)