3 System Description
EDBC250SBC |1.1
l
ll
l
14
To snap on a single module
1. Push up the module against the mounting rail from below, allowing the metal spring to
snap in between mounting rail and mounting area as illustrated.
2. Push the module against the mounting wall until is snaps in.
Figure 4: Rail mounting of module
To interconnect two modules
1. After snapping on the first module to the rail, snap on the second module about 1cm away
towards the right of the first module.
2. Push the second module along the rail towards the first module until you hear the locking
device snap in.
To disconnect two modules
1. Push down the unlock button (see Figure 5) of the module that you wish to disconnect from
the module to the left of it.
2. Push both modules away from one another until they are about 1 cm apart.
To Next Page
Loading...
