Parameter setting
With keypad
6−3
L
EDB82MV752 EN 5.2
Function keys
Key Function Explanation
Enable drive controller X3/28 must be set to HIGH level.
Inhibit drive controller (CINH) or quick stop (QSP) Configuration in C0469.
Change function bar 1 function bar 2
To the right/left in the active function bar. The current function is framed.
Increase/decrease value.
change quickly: keep key pressed
Only blinking values can be changed.
Save parameters if is blinking.
confirmation by
STOrein the display.
Status displays
Description of the fault messages: ( 8−1 ff)
Display Meaning Explanation
Ready for operation
Pulse inhibit Power outputs inhibited
"
Set current limit is exceeded C0022 (in motor mode) or C0023 (in generator mode)
#
Warning active
$
Error active
Bar graph display
Set value in C0004 in %.
(Lenze setting: device utilisation C0056).
Display range: − 180 % ... + 180 % (every scale line = 20 %)
Function bar 1
Function Meaning Explanation
Setpoint selection via Not possible with active password protection (display = "loc")
Display function:
User menu, memory location 1 (C0517/1), display
Display active parameter set
Active after every mains connection
Select codes Active code number shown on four−digit display
Select subcodes Active subcode number shown on three−digit display
Change parameter value of a (sub−) code Current value shown on five−digit display !
%
Display values with more than 5 digits
H: high−order digits "HI" shown on display
L: low−order digits "lo" shown on display
Function bar 2
Function Meaning Explanation
Select parameter set 1 ... parameter set 4 for changing Display e. g. PS 2 ()
Activating parameter sets can be effected via digital signals only
(configuration with C0410).
&
Select node on system bus (CAN) The node selected can be parameterised from the current drive.
' = function active
Select menu
The user menu is active after every mains switching. If required,
change to all.
user List of the codes in the user menu (C0517)
all List of all codes
funci Only specific codes for bus function modules, e.g. INTERBUS,
PROFIBUS−DP and LECOM-B
To Next Page
Loading...