Lenze ECSEE020 - Page 162

Index12

162
EDBCSXE040 EN 6.0
Configuration, 76
− codes, 134
− monitoring, 67 , 111
brake chopper IGBT, 117
brake resistor, 116
communication, 118
current, 117
DC bus, 115
fan, 115
heatsink temperature, 115
mains, 113
temperature inside the device, 115
voltage supply of control electronics, 115
− monitoring functions, overview, 109
− system bus (CAN)
bus status, 107
control word, assignment, 105
determining the master in the drive system, 100
display of telegram data, 107
display of the resulting identifiers, 99
Individual addressing, 98
Making a reset node, 104
Node Guarding, 102 , 119
Setting the baud rate, 95
setting the boot−up time, 101
setting the cycle time , 101
setting the delay time, 101
setting the mode for process data transfer, 101
Setting the node address, 95
status words, assignment, 106
− Table of attributes, 152
− via automation interface (AIF), 76
− via system bus interface (CAN), 76
Configuring power supply enable input, 64
Conformity, 19
Connection
− Capacitor module ECSxK..., 47
− DC bus, 38 , 42
− external brake resistor, 45
type ERBD..., 46
type ERBM..., 46
type ERBS..., 46
− Internal brake resistor, 43
− mains, 38 , 40
Control connections
− Cable cross−sections, 42 , 50
− Tightening torques, 42 , 50
Control signals, 48
Control terminals, 48
Control word, assignment, 105
Control/signal cables, shield connection, 48
Controller, 9
Controller enable, 51
Cooling, 26
Current, monitoring, 117
Cyclic process data objects, 85
D
Data telegram, 77
Data, general electrical, 20
DC bus
− connection, 38 , 42
− monitoring, 115
− reducing voltage dips, 64
DC−bus voltage, switching thresholds, 62
Defining boot−up master, 100
Defining master in the drive system, 100
Definition of notes used, 18
Definitions, 9
Device protection, 16
Diagnostics, 120
− via diagnostics PDO (CAN2_OUT), 127
− with Global Drive Control (GDC), 120
− with PCAN−View, 124
− with XT EMZ9371BC keypad, 123
Diagnostics PDO (CAN), 108
Diagnostics PDO (CAN2_OUT), 127
Digital frequency cables, 156
Digital frequency distributor, 156
Digital inputs, 51
− controller enable, 51
− power supply enable, 51
Digital outputs, 51
− controller enable, 51
− power supply enable, 51
Dimensions, 25 , 27 , 31
− ECSCE...power supply module , 31
− ECSEE series power supply module, 25
− power supply module ECSDE..., 27
− power supply module ECSEE..., 25
DIP switch, 95
Discharge current to PE, 20
Drive system, 9
Drive system on the mains, 36
− operation on public supply systems, EN 61000−3−2, 37
− supply forms / electrical supply conditions, 37