Lenze ECSEE020 - Page 166

Index12

166
EDBCSXE040 EN 6.0
Power supply enable, 51
Power supply module, 9
− ECSCE..., dimensions, 31
− ECSDE..., dimensions, 27
− ECSEE..., dimensions, 25
Power supply modules
− application as directed, 12
− identification, 12
Power terminals, 38
− DC bus connection, 38 , 42
Process data, 78
− Setting the mode for transfer, 101
− structure, 83
Process data objects
− addressing, 94
− available, 82
− cyclic, 85
− event−controlled, 87
− transfer, 84
Process data telegram, 83
Process data transfer, 82
Protection of persons, 16
Protective insulation, 20
Protective measures, 20
Protective separation, 20
R
Rated data, 21 , 22
− electrical data, 21
− external brake resistor
type ERBD..., 23 , 157
type ERBM..., 22 , 157
type ERBS..., 23 , 158
− internal brake resistor, 21
Reducing voltage dips, 64
Residual hazards, 16
Responses, 68 , 111
− message, 68 , 112
− short−circuit braking TRIP, 68 , 112
− TRIP, 68 , 112
− warning, 68 , 112
S
Safety instructions, 13
− definition, 18
− for Lenze power supply modules, 13
− layout, 18
Screw−tightening torques, 39
Setting chopper operation, 63
Setting of boot up time , 101
Setting of cycle time, 101
Setting short−circuit braking, 63
Setting the address, via DIP switch, 96
Setting the baud rate, 95
Setting the mains voltage, 62
Setting the mode for process data transfer, 101
Setting the node address, 95
− via DIP switch, 96
Setting the operating mode
− control via digital inputs, 60
− operation via EtherCAT, 61
− operation via system bus (CAN), 59
Shield connection, control/signal cables, 48
Shielded cables, 39
Shielding
− cables, 39
− EMC, 35
Short−circuit braking TRIP, 68 , 112
Site altitude, 19
Specification of the transmission cable, 54
Standards, 19
States, CAN network, 79
Status words, assignment, 106
STOP key of keypad XT, 65
Structure of the process data, 83
Supply forms / electrical supply conditions, 37
Switching thresholds, DC−bus voltage/brake resistor, 62
Sync telegram, 86
Synchronisation, cyclic process data objects, 86