Mechanical installation
Mounting steps
Panel PC EL 1800(s) / EL 1850(s)
5
34
BA_ELx8xx EN 3.0
5.3 Mounting steps
5.3.1 Panel PC EL 1800(s) / EL 1850(s)
How to perform the installation:
1. Cut the mounting cutout into the control board ( 33).
2. Check that the gasket under the front panel is located correctly.
3. Place the device in the mounting cutout and secure it against falling−down with one
hand.
4. Fit all screw clamp fixings as explained below:
ELx7xx−011
– Insert the screw clamp fixing into the slot in the housing of the device (see above
figure).
– Press the screw clamp fixing downwards, tilt it towards the housing and check
that it has firmly snapped into place.
– Tighten the screw clamp fixing hand−tight with a screwdriver.
5. Check that the device is securely located in the mounting cutout and that the front
panel gasket is located correctly.
– If necessary, realign the device/gasket.
– If the gasket is not located correctly, protection class IP65 is not achieved on the
front of the device!
To Next Page
Loading...
