Lenze g500-S2100 - Page 28

Mechanical installation
Mounting of g500 short/servo adapters with clamping connection
Maximum permissible load at the motor adapter
4
28
Lenze ¯ MA 12.0018 ¯ 4.1
8. Cleaning:
¯ Thoroughly clean and degrease hollow shaft bore and motor shaft journal, Fig. 4.
A
3
2
1
Fig. 4 Shaft surfaces
1 Gearbox  degrease
2 Bell housing
3 Motor
Mounting
1. Install the gearbox vertically so that the drive end is on top and securely fasten it.
2. Locate the position of the mounting hole and remove the plug (5) from the bell
housing (2) and keep it!
1
2
5
Fig. 5 Removing the plug from the bell housing
1 Gearbox 5 Plug
2 Bell housing
3. Align the slots of the gearbox drive hollow shaft and the clamping ring to each
other and to the mounting hole (Fig. 6).