Lenze MSEMA Series - Page 54

Mechanical installaon
Important notes
•
You must install the product according to specicaons in the chapter "standard and operang" condi-
ons.
4Standards and operang condions ^ 78
•
The technical data and the data regarding the supply condions can be found on the nameplate and in
this documentaon.
•
Observe the informaon relang to the surface and corrosion protecon.
•
Ambient media − especially chemically aggressive ones − may damage sha sealing rings, lacquers and
plascs. If required, contact your responsible Lenze subsidiary.
Transport
•
Ensure appropriate handling.
•
Make sure that all component parts are safely mounted. Secure or remove loose component parts.
•
Only use safely xed transport aids (e.g. eye bolts or support plates).
•
Do not damage any components during the transport.
•
Avoid electrostac discharge on electronic components and contacts.
•
Avoid impacts.
•
Check the carrying capacity of the hoists and load handling devices. The weights can be obtained from the
shipping documents.
•
Secure the load against pping and falling down.
•
Standing under a suspended load is forbidden.
Preparaon
•
Remove protecon covers from the shas
•
Remove corrosion protecon from the shas and contact surfaces (ange/foot)
•
If necessary, remove dirt using standard cleaning solvents
NOTICE
Material damage caused by solvents!
Solvents can destroy bearings and sealing rings.
▶
Bearings or sealing rings must not come into contact with the solvent!
Installaon
•
Avoid resonances with the rotaonal frequency and double mains frequency.
•
The mounng surfaces must be plane, torsionally rigid and free from vibraons.
•
The mounng areas must be suited to absorb the forces and torques generated during operaon.
•
Ensure an unhindered venlaon.
•
For versions with a fan, keep a minimum distance of 10 % from the outside diameter of the fan cover in
intake direcon.
Dimensions
Dimensions are contained in the conguraon document.
Mechanical installaon
Important notes
54