REV 07a / 01_ 2012
12
Two additional commands have been added for the support of the I2C interface:
o i2c? this allows to query the actual I2C adress
o i2c this allows to set the I2C adress to any fixed value between 10 and 99
(for example i2c15 sets the adress 15
After a new adress has been set, it remains unchanged even after switch off the power supply, as this
adress is stored in the flash memory of the controller.
Important: Please write the commands in small letters!! The commands must be activated by a
carriage return!!
To Next Page
Loading...
