Important Information:
The Letro Legend II automatic pool cleaner comes ready to connect into a female threaded
1-1/2" dedicated return line. Other connections are possible, but they require additional fittings. For
more information, please contact our Technical Support Department at 1-800-223-1695. Also, if you
have a chlorinator, solar system or other air inducing equipment, please contact our Technical
Support Department before you install the Legend II.
The following are important facts to remember before installing and operating the Legend II.
1. Always disconnect the Legend II from the pool wall when cleaning or back washing the pool
filter.
2. After cleaning or back washing, let the filtration system run for at least five minutes before
reconnecting the Legend II.
3. New plumbing lines should be flushed out before installing the Legend II.
4. The Legend II should not be used to remove plaster dust in new pools.
5. Always remove the Legend II before swimmers enter the pool.
6. Always handle the Legend II with care. Do not let children or pets play with the unit:
it is not a toy.
7. Always pick up the Legend II by the Vacuum Tube especially when lifting the unit out of the
water.
8. Unless checking the wheel RPM, do not handle the Legend II while it is operating.
9. Always remove the Legend II from the pool before chemical shock treatments. As a rule, any
pool water that is unsafe for swimming is unsafe for the Legend II.
10. Carefully cut the feed hose following the instructions on Page 7.
By following these simple guidelines, you can help protect against injury and prolong the life of
your Legend II.
Before the Legend II is installed, please take a moment to record the serial number. This number
is located on your warranty card and on the back of the Legend II near the rear jet. You will be asked
this number when you contact our Technical Support Department.
SERIAL #__________________________________
LETRO LEGEND II
LX 2000
To Next Page
Loading...