Letro LEGEND II - Pressure Testing Instructions; Cutting the Feed Hose for Optimal Length

2. With the pool pump on, hold the free end
of the Feeder Hose underwater. Gently pull
the hose to the farthest end of the corner of
the pool, do no stretch the hose. (The
Legend II usually will not climb the top step,
so you do not need to include it in the
measurement.) If the hose just reaches the
farthest point of your pool, and without any
excess hose hanging over the deck, then go
to Section F.
3. If the Feeder Hose extends past the
farthest end of the pool, mark the excess
hose hanging over the deck, turn off your
pool pump, and cut first 6' section of hose,
closest to the wall, the length of excess.
4. IMPORTANT: Please double check the
hose length to insure you will be getting the
maximum performance from your pool
cleaner. The hose lengthens when under
pressure (when your pump is on).
D. Pressure Testing Instructions
1. Make sure the pool filter is clean before
conducting this pressure test.
2. Twist lock the Wall Fitting with Feeder
Hose into the Wall Adapter.
3. Have someone hold the Pressure Tester
end of the Feed Hose beneath the water
while you turn on the pool pump. Continue
holding the hose under the water and cover
the large hole of the pressure tester.
4. Reach down and feel around the
Pressure Relief Valve on the Wall Fitting to
see if the Relief Valve is releasing any water
pressure. If valve is releasing water
pressure go on to section E. If it is not, the
pool filtration pump may not have sufficient
amount of water pressure to operate the
Legend II.
BEFORE YOU GO TO THE NEXT STEP,
CONTACT OUR TECHNICAL SUPPORT
DEPARTMENT AT: 1-800-223-1695
E. Cutting the Feed Hose (see Hose
Diagram on Page 15)
The Hose assembly comes in 6 sections
covering approximately 30 ft. of the pool,
which provides ample hose for most
residential pools. For larger or smaller pools
see Page 14 for instructions for Adding or
Deleting Additional Feeder Hose.
1. Take Feeder Hose out of box and lay the
hose straight in the sun for one day if
possible, (this will take any memory out of
the hose due to being coiled up in the box).