10
release the POWER button to toggle between high, medium, and
low. Press MODE to save the selection.
FOG MODE
The Fog Mode can be used in foggy/rainy
conditions to screen out false readings from
raindrops or other atmospheric interference to
provide an accurate range. Fog Mode changes
the algorithm to look for the “last” target. To
increase ranging accuracy always range the
ground around the pin/flag when Fog Mode is on.
TO ACTIVATE FOG MODE:
1) Press POWER to activate the rangefinder.
2) Press and hold MODE for at least 2 seconds and then release
to enter the Quick Set Menu; the word “Fog” will now appear
in the upper display.
3) While the word “Fog” is displayed, press and release POWER
as necessary until the word “On” is displayed in the lower
portion of the display.
4) To save the changes and return to ranging mode, let the unit
sit idle for at least 30 seconds until an automatic power-down
occurs, or simply press and hold MODE for at least 2 seconds.
To continue through the Quick Set Menu and manipulate
To Next Page
Loading...
Need help?
General
