23
press MODE to save your selection and move on to the
altitude input.
3) The last saved altitude will be flashing in the
bottom portion of the display. If you wish to
input an altitude other than the one shown,
proceed to step 4. To save the shown altitude
and return to ranging mode, let the unit sit
idle for at least 30 seconds until an automatic
power-down occurs, or simply press and hold
MODE for at least 2 seconds. To continue through the Quick
Set Menu and manipulate another feature, press and release
MODE until the appropriate mode is displayed.
4) Press POWER to begin incrementing through the altitude
settings. The default setting is 1000 feet. Pressing POWER
will increment through a range of 0 feet to 9,999 feet in 500
foot increments. When the appropriate altitude is displayed,
you have completed the input process for setting up the
Temperature and Altitude at which the striking distances were
measured. To save the changes and return to ranging mode,
let the unit sit idle for at least 30 seconds until an automatic
power-down occurs, or simply press and hold MODE for at
least 2 seconds. To continue through the Quick Set Menu and
manipulate another feature, press and release MODE until the
appropriate mode is displayed.
To Next Page
Loading...
Need help?
General
