levante-products.com
LEV0608bb/Page 10 of 12/Issue 1/06.19
BASIC SETTINGS
Setting the Time and Date
The time and date are factory set and changes
between summer and winter time are handled
automatically by the unit.
1. Switch the slider to TIME/DATE.
2. The hour symbols will flash, use the +/–
buttons to adjust.
3. Press the Next
button and the minute
symbols will flash, use the +/– buttons to
adjust.
4. Press the Next
button and the day
date will flash, use the +/– buttons to
adjust the day.
5. Press the Next
button and the month
date will flash, use the +/– buttons to
adjust the month.
6. Press the Next
button and the year
date will flash, use the +/– buttons to
adjust the year.
Setting the Backlight
The backlight can either be set permanently
ON or OFF.
The programmer backlight is pre-set to be
permanently OFF. When the backlight is
permanently OFF, the backlight will turn
ON for 15 seconds when + or – button is
pressed, then turn OFF automatically.
To change setting to permanently ON, move
the slider to TIME/DATE. Press the Next
button repeatedly until Lit is displayed. Press
+ or – to turn backlight ON or OFF. Press
the Next button or wait for 15 seconds
to automatically confirm and return to Run
Mode.
N.B. Do not use Advance or +HR Boost
Button to activate the backlight as it
may engage the Advance or +HR facility
and turn on the boiler. Only use the
Home button.
Resetting the Unit
Press the reset button with a non-metallic
pointed tool to reset the unit. This will
restore the built in programme and also
reset the time to 12:00pm and the date to
01/01/2000. To set the time and date, (please
refer to page 6).
N.B. As a safety feature after resetting the
unit will be in OFF operating mode.
Reselect your required operating mode
(page 4). Use of excessive force may
result in the reset button sticking behind
the front cover of the programmer. If
this happens the unit will “freeze” and
the button can only be released by a
qualified installer.
Power Interruption
In the event of a mains supply failure the
screen will go blank but the back-up battery
ensures that the programmer continues
to keep the time and retain your stored
programme. When power is restored, switch
the slider to RUN to return to Run mode.
To Next Page
Loading...