LevelOne GVT-2010 User Manual

1
Brief introduction
Many thanks for purchasing Gigabit Ethernet optical Media
Converter! This product supports IEEE802.3
10/100/1000Base-Tx and 1000Base-X protocol, as well as full
duplex and half duplex mode. This manual is for adaptive
10M/100M/1000M Media Converter. The following guide is
for customer’s reference. Comply with IEEE 802.3af/at, its
advanced auto-sensing algorithm enables taking power from
IEEE 802.3af/at Power Source Equipment (PSE) or Power
over Ethernet (PoE) injector. It also supports high safety with
short circuit protection and power-in auto-detection (power
from AC/DC power adapter or PSE device).
Purchasing guide for LevelOne optical transceivers
Model
Specifications
GVT-2010
10/100/1000M adaptive with SFP slot
Packing list
Please check the following items in the package before
installing the transceiver.
The PoE PD GE Media Converter 1set
AC/DC adaptor (optional) 1pc
User manual 1copy
Please contact the dealer immediately for any loss or damage
to the above items.
Installation
1. Interface
RJ-45 interface
The transmission media adopts CAT5e twisted-pair with
typical length of 100 meter. It features the function of
automatically identifying the through line and cross wire
(10/100M).
Fiber interface
LC/SC fiber interface is of duplex mode type, including two
interfaces, namely TX and RX. When the two sets of optical
transceiver are interfaced or connected to switch with fiber
interface, the fiber is in cross connection, namely "TX-RX",
"RX-TX" (direct butting for single optical fiber).
2. Connection
The power sourcing equipment (PSE) with RJ-45 interface is
connected to RJ-45 jack of media converter through
twisted-pair. And the multi/single mode fiber is connected to
LC/SC fiber interface of the SFP module. Then switch on. The
corresponding LED is on for correct connection. (See the table
below for the LED indicator lamp)
- Please make sure that the power of PSE device is turned
on, or else the converter will not work.
- In case that no 802.3af/at PSE is available or PSE with
PoE power fails, you may install an AC-DC adapter for a
backup solution. Do not connect PSE TP port and AC-DC
adapter at a time.
Figure 1 Schematic drawing of connection
Explanation for LED indicator lamp
LED indicator lamps serve as device monitoring and trouble
display. The following is the explanation for each LED
indicator lamp.
LED
Status
Explanation
FX
Link/Act
On
Connection status display for fiber link.
“ON” indicates that Fiber link is in correct
connection.
Blink
Active status display of fiber link.
“Blink” when fiber data is present.
TP
Link/Act
On
Connection status display for electric link.
“ON” indicates that electric link is in correct
connection.
Blink
Active status display of fiber link.
“Blink” when TP data is receiving.
FDX
On
The connected device of media converter is
working at full duplex mode.
Off
The connected device of media converter is
working at half duplex mode.
PWR
On
Power is on and normal or taking power from
PSE device normal.
Off
Power is abnormal or taking power from PSE
device abnormal.
TP 100
On
Transfer rate of electric interface is 100Mbps.
TP 1000
On
Transfer rate of electric interface is
1000Mbps.
Note: when both TP 100 and TP 1000 LED indicator is OFF,
the transfer rate of TP port is 10Mbps.

LevelOne GVT-2010 Specifications

General

Brand	LevelOne
Model	GVT-2010
Category	Media Converter
Language	English