The port has no active network cable connected, or it is
not established a link to connected device. Otherwise, the
port may have been disabled through the switch user
interface.
DIP Switch
By configure the DIP Switch, users can perform the Rapid Ring tasks.
Detail setting can refer to Rapid Ring User Manual.
Reset Button
By pressing the Reset Button for certain period of time, users can perform
the following tasks.
• Reset the Switch
to reboot and get the switch back to the previous configuration
settings saved.
• Restore the Switch to Factory Defaults
to restore the original factory default settings back to the switch.
Note:
According to the table below, users can easily judge which task is being
performed by reading the LED behaviors while pressing the Reset button.
Once the LED behaviors are correctly displayed, users may just
release the button.
Table 6: Reset Button Descriptions
To Next Page
Loading...
