LevelOne PLI-4052 - Adding a Bridge to Existing Network

25
The procedure is as follows:
1. Press and hold the Security button on Bridge A for 10 seconds. Release it when the Power
light flashes. The password to Bridge A has just been erased. It must now be linked to your
network to adopt the new network security key.
2. Press and hold the security button on Bridge B for 10 seconds and release it when the Power
light flashes. The password to Bridge B has just been erased. It must now be linked to your
network to adopt the new network security key.
3. Currently, Bridge A and Bridge B are not networked
4. Press and hold the Security button on Bridge A for 2 seconds then release.
5. The Power light on Bridge A starts to flash.
6. Within 120 seconds after the Power light on Bridge A starts to flash, press and hold the
Security button on Bridge B for 2 seconds then release.
7. Both Bridge A and Bridge B are now networked together.
4.2 Adding Bridge C to existing Network AB (Network ABC)
One unassociated Bridge C is added to an existing Network AB.