LevelOne POI-3000 - Step 4. Connect Output Cables

 Ligue a porta "Power+Data" (Entrada de Dados) do Separador e a porta "P+D/Out"
(P+D/Saída) do Injector através do cabo Ethernet e certifique-se de que o indicador LED
"Power" (Energia) está ligado.
 rn med
Ethernet kabel. 
 " (Napajanje + podatki) razdelilnika in vrata "P+D/Out"
injektorja s kablom Ethernet ter zagotovite, da je "Power" (Napajanje) LED razdelilnika

 透過乙太網路線連接在網路電源分歧器上的 埠和網路電源供應器的
埠,並確定網路分岐器上的 LED 燈有亮。
 Splitter 의  포트와 Poe injector 의  포트를 랜케이블로 연결,
Splitter 의 전원 LED 점등 확인.
 er+Data" (+)   
"+/"     Ethernet  ,  
  " .
 


 Connect "Power OUT" cable of Splitter to power jack of the network device, and connect
"Data OUT" cable of Splitter to RJ45 port of network device.
Step 4.