Need help?Do you have a question about the LevelOne POI-3000 and is the answer not in the manual?
Connect the AC power cord to the PoE injector and verify the power LED illuminates.
Connect the 'Data/In' port to a Gigabit switch and set the voltage using the DIP switch.
Connect the Splitter's 'Power+Data' port to the Injector's 'P+D/Out' port via Ethernet cable.
Connect the 'Power OUT' and 'Data OUT' cables from the Splitter to the network device.
Check if the network device is powered on and all cables are connected correctly.
Connect the AC power cord to the PoE injector and verify the power LED illuminates.
Connect the 'Data/In' port to a Gigabit switch and set the voltage using the DIP switch.
Connect the Splitter's 'Power+Data' port to the Injector's 'P+D/Out' port via Ethernet cable.
Connect the 'Power OUT' and 'Data OUT' cables from the Splitter to the network device.
Check if the network device is powered on and all cables are connected correctly.
General| Brand | LevelOne |
|---|---|
| Model | POI-3000 |
| Category | Network Router |
| Language | English |
To Next Page
