Easy configure AP2 via
WEC.
Master to Slave WEC:
1. Trigger AP1 into WEC configuration process via
pressing the WEC button for 3 second.
2. Trigger AP2 into WEC configuration process via
pressing the WEC button for 3 second.
3. It takes 30 ~ 60 seconds for the device to finish
the WEC configuration process.
(P.S:VAP1 of 2.4GHz or 5GHz in Salve Mode
will get WiFi profile from Master AP1.)
Easy configure AP3 via
WEC.
Slave to Slave WEC:
1. Trigger AP2 into WEC configuration process via
pressing the WEC button for 3 second.
2. Trigger AP3 into WEC configuration process via
pressing the WEC button for 3 second.
3. It takes 30 ~ 60 seconds for the device to finish
the WEC configuration process.
(P.S:VAP1 of 2.4GHz or 5GHz in Salve Mode
will get WiFi profile from Master AP1.)
Easy configure AP4 via
WEC.
Slave to Slave WEC:
1. Trigger AP3 into WEC configuration process via
pressing the WEC button for 3 second.
2. Trigger AP4 into WEC configuration process via
pressing the WEC button for 3 second.
3. It takes 30 ~ 60 seconds for the device to finish
the WEC configuration process.
(P.S:VAP1 of 2.4GHz or 5GHz in Salve Mode
will get WiFi profile from Master AP1.)
Mount the devices AP1,
AP2, AP3, and AP4 to
expected locations.
1. Install AP1 to its location first and verify its
wireless network connectivity with a client
device.
2. Install AP2 to its location and verify its wireless
network connectivity with a client device at the
location beyond the service range of AP1.
Besides, You can also check the AP2’s WiFi
LED, it should be “Solid Amber” if AP2 already
connected a Master AP AP1.
3. Install AP3 to its location and verify its wireless
network connectivity with a client device at the
location beyond the service range of AP2.
Besides, You can also check the AP3’s WiFi
To Next Page
Loading...