Leviton TOGGLE TOUCH TGI06-10

To Next Page

FEATURES

• Conventional Toggle styling • Soft Fade ON

• Individual touch plates - simplify Dimming adjustments • Maintains DIM level when turned OFF

• Simple adjustment of DIM level - 'just a touch' • Fits standard wallbox

FCC COMPLIANCE STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

must not cause harmful interference, and (2) This device must accept any interference received, including interference

that may cause undesired operation.

INSTALLATION INSTRUCTIONS

WARNING: TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE ELECTRICAL CODES AND

REGULATIONS.

WARNING: IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED

ELECTRICIAN.

CAUTION (For Incandescent Only): USE WITH INCANDESCENT OR 120V HALOGEN FIXTURES ONLY.

CAUTION (For Magnetic Low-Voltage Only):

1. USE WITH MAGNETIC LOW-VOLTAGE TRANSFORMERS, INCANDESCENT, OR 120V HALOGEN FIXTURES

ONLY. USE A LEVITON ELECTRONIC LOW-VOLTAGE DIMMER TO CONTROL ELECTRONIC (SOLID STATE)

LOW-VOLTAGE TRANSFORMERS.

2. WHEN A MAGNETIC LOW-VOLTAGE CIRCUIT IS OPERATED AT A DIM LEVEL, WITH ALL LAMPS INOPERATIVE,

EXCESS CURRENT MAY FLOW THROUGH THE TRANSFORMER. TO AVOID POSSIBLE TRANSFORMER

FAILURE DUE TO OVERCURRENT, USE A TRANSFORMER THAT INCORPORATES THERMAL PROTECTION OR A

FUSE AT THE PRIMARY WINDINGS.

OTHER CAUTIONS:

1. USE ONLY ONE (1) DIMMER PER LOAD. THE SWITCH(ES) WILL TURN THE LIGHT ON AT THE BRIGHTNESS

LEVEL SELECTED AT THE DIMMER.

2. IN A 3-WAY APPLICATION, THE DIMMER MUST BE CONNECTED TO THE LOAD.

3. DISCONNECT POWER WHEN SERVICING FIXTURE OR CHANGING LAMPS.

4. USE THIS DEVICE ONLY WITH COPPER OR COPPER

CLAD WIRE. WITH ALUMINUM WIRE USE ONLY DEVICES

MARKED CO/ALR OR CU/AL.

MULTI-GANG INSTALLATION:

When ganging dimmers, the side sections of the mounting strap

must be removed. Use pliers to carefully bend side sections

back and forth until they break off (see Figure 1). The side

sections dissipate heat, so removing them requires a derating of

the dimmer's capacity (see chart).

MAXIMUM BULB WATTAGE (For Magnetic Low-Voltage

Only):

Low-voltage dimmers are rated in Volt-Amps (VA). The

maximum bulb wattage is determined by the efficiency of the

transformer in the low-voltage lighting system. Transformer

efficiencies will vary from different manufacturers; consider 75%

efficient as average. Use the chart to determine maximum bulb

wattage for typical transformer efficiency ratings.

TO INSTALL:

WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN

OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST

THAT POWER IS OFF BEFORE WIRING!

2. Remove existing wallplate and switch or dimmer, if

applicable.

3. Remove 3/4" (1.9 cm) of insulation from each circuit

conductor. Make sure that ends of conductors are straight.

4. Connect lead wires per appropriate WIRING DIAGRAM as

follows:

WARNING: CONNECT A MAGNETIC LOW-

VOLTAGE DIMMER ONLY TO THE PRIMARY

(HIGH-VOLTAGE) SIDE OF A MAGNETIC LOW-VOLTAGE

TRANSFORMER. NOTE: Common terminal of a 3-Way

Switch is usually labeled and/or BLACK. Twist strands of

each lead tightly and, with circuit conductors push firmly into

appropriate wire connector. Screw connectors on clockwise

PK-92952-10-00-0A

For Technical Assistance Call:

1-800-824-3005 (U.S.A Only)

1 800 405-5320 (Canada Only)

www.leviton.com

LIMITED 2 YEAR WARRANTY AND EXCLUSIONS

Leviton warrants to the original consumer purchaser and not

for the benefit of anyone else that this product at the time of its

sale by Leviton is free of defects in materials and workmanship

under normal and proper use for two years from the purchase

date. Leviton’s only obligation is to correct such defects by

repair or replacement, at its option, if within such two year

period the product is returned prepaid, with proof of purchase

date, and a description of the problem to Leviton

Manufacturing Co., Inc., Att: Quality Assurance

Department, 59-25 Little Neck Parkway, Little Neck, New

York 11362-2591 (In Canada send to Leviton Mfg. of Canada

Ltd., 165 Hymus Blvd., Point Claire, (Quebec), Canada H9R

1E9). This warranty excludes and there is disclaimed liability

for labor for removal of this product or reinstallation. This

warranty is void if this product is installed improperly or in an

improper environment, overloaded, misused, opened, abused,

or altered in any manner, or is not used under normal operating

conditions or not in accordance with any labels or instructions.

There are no other or implied warranties of any kind, including

merchantability and fitness for a particular purpose, but if any

implied warranty is required by the applicable jurisdiction, the

duration of any such implied warranty, including merchantability

and fitness for a particular purpose, is limited to two years.

Leviton is not liable for incidental, indirect, special, or

consequential damages, including without limitation, damage

to, or loss of use of, any equipment, lost sales or profits or

delay or failure to perform this warranty obligation. The

remedies provided herein are the exclusive remedies under

this warranty, whether based on contract, tort or otherwise.

Single Pole (One location) or

3-Way (Multi-location)

120VAC, 60Hz

Incandescent

Cat. No. TGI06-10, 600W

Cat. No. TGI06-1L, 600W (Lighted)

Cat. No. TGI10-1L, 1000W (Lighted)

Magnetic Low-Voltage

Cat. No. TGM10-1L, 1000VA (Lighted)

Total minimum wattage must

exceed 40W and 40VA

INSTALLATION INSTRUCTIONS

PK-92952-10-00-0A

Mounting Strap

Side Sections

ON/OFF

Toggle

Upper

Touch Plate

Lower

Touch Plate

LED

(optional)

Figure 1 - Dimmer Functions

Two More than

Rating Single Gang

2 Gang

1000VA 750W 600W 525W

MAXIMUM BULB WATTAGE AT 75% EFFICIENCY

Two More than

Cat. No. Single Gang

2 Gang

TGI06-10, TGI06-1L 600W 500W 400W

TGI10-1L 1000W 800W 700W

TGM10-1L 1000VA 800VA 700VA

MAXIMUM LOAD PER DIMMER FOR MULTI-GANG

PK-92952-10-00-0A 2/24/2000, 9:59 AM1

Need help?

Do you have a question about the Leviton TOGGLE TOUCH TGI06-10 and is the answer not in the manual?

The device described in this manual is the Leviton Toggle Touch™ Dimmer, designed for single-pole (one location) or 3-way (multi-location) control of lighting. It operates on 120VAC, 60Hz power.

Function Description:

The Toggle Touch™ dimmer combines conventional toggle styling with modern touch-plate dimming. It allows users to turn lights ON/OFF and adjust brightness levels with simple touch interactions. For incandescent and 120V halogen fixtures, it offers models with 600W (Cat. No. TG106-10, TG106-1L) and 1000W (Cat. No. TGI10-1L) capacities. For magnetic low-voltage lighting systems, a 1000VA model (Cat. No. TGM10-1L) is available. The device features a "Soft Fade ON" effect and maintains the last set DIM level when turned OFF. An optional LED indicator provides visual feedback on the ON/OFF status.

Important Technical Specifications:

Power: 120VAC, 60Hz
Load Types:
- Incandescent/120V Halogen: 600W (TG106-10, TG106-1L), 1000W (TGI10-1L)
- Magnetic Low-Voltage: 1000VA (TGM10-1L)
Minimum Wattage: Total minimum wattage must exceed 40W (for incandescent) and 40VA (for magnetic low-voltage).
Wiring: Designed for use with copper or copper-clad wire. For aluminum wire, only devices marked CO/ALR or CU/AL should be used.
FCC Compliance: Complies with part 15 of the FCC Rules, ensuring it does not cause harmful interference and accepts any interference received.
Multi-Gang Installation: When ganging dimmers, the side sections of the mounting strap must be removed. This reduces the dimmer's capacity (derating).
- Maximum Load Per Dimmer for Multi-Gang:
  - TG106-10, TG106-1L: Single - 600W, Two Gang - 500W, More than 2 Gang - 400W
  - TGI10-1L: Single - 1000W, Two Gang - 800W, More than 2 Gang - 700W
  - TGM10-1L: Single - 1000VA, Two Gang - 800VA, More than 2 Gang - 700VA
- Maximum Bulb Wattage at 75% Efficiency (Magnetic Low-Voltage Only):
  - 1000VA Rating: Single - 750W, Two Gang - 600W, More than 2 Gang - 525W
  - Note: Transformer efficiencies vary; 75% efficiency is considered average for these ratings.

Usage Features:

ON/OFF Control:
- Single Pole: Toggle UP for ON, Toggle DOWN for OFF.
- 3-Way: Toggle UP or DOWN until the LED turns OFF for ON; Toggle UP or DOWN until the LED turns ON for OFF.
Dimming Adjustment:
- BRIGHTEN: Touch and hold the UPPER touch plate until the desired brightness level is reached.
- DIM: Touch and hold the LOWER touch plate until the desired dim level is reached.
ON/OFF LED (Lighted Version): The LED is OFF when lights are ON, and ON when lights are OFF.
Magnetic Low-Voltage Specific Cautions:
- Must be used with magnetic low-voltage transformers, incandescent, or 120V halogen fixtures only.
- For electronic (solid state) low-voltage transformers, a Leviton electronic low-voltage dimmer should be used instead.
- To prevent transformer failure due to overcurrent when operating at a dim level with all lamps inoperative, use a transformer with thermal protection or a fuse at the primary windings.
- Connect the magnetic low-voltage dimmer only to the primary (high-voltage) side of a magnetic low-voltage transformer.
General Cautions:
- Use only one dimmer per load.
- In a 3-way application, the dimmer must be connected to the load.
- Disconnect power before servicing fixtures or changing lamps.
- Always turn off power at the circuit breaker or fuse and test that power is off before wiring.

Maintenance Features:

Cleaning: To clean the touch plate, wipe it with a clean, damp cloth using only clean water, then dry thoroughly.
Troubleshooting: The manual provides guidance for common issues:
- Lights not turning ON/OFF LED not turning ON: Check for tripped circuit breaker/fuse, burned-out lamp, or incorrect connection to line neutral.
- Dimmer not operating (lights not dimming/brightening): Check for miswiring of dimmer BLACK wire to lamp and dimmer BLUE wire to LINE Hot.
- Lights Flickering: Check for bad lamp connection or if lamp power is less than 40W/40VA.

Warranty:

Leviton offers a limited 2-year warranty to the original consumer purchaser, covering defects in materials and workmanship under normal and proper use. The warranty excludes labor for removal/reinstallation and is void if the product is improperly installed, overloaded, misused, opened, abused, altered, or not used according to instructions. Remedies are limited to repair or replacement at Leviton's option.