13
Resetting the Check
Filter Indicator
Reset the Check Filter Indicator when:
A.
lights up.
1. Replace the filter. (see page 14)
2. Turn on the air purifier.
3. Press and hold
for 3 seconds.
4.
will turn o when successfully
reset.
B. The filter was changed before
lit up.
1. Press and hold
for 3 seconds.
This will turn on
.
2. Press and hold
again for
3 seconds.
3.
will turn o when successfully
reset.
CARE & MAINTENANCE
Figure 3.1
will light up as a reminder to check the
filter. Depending on how much you use the
air purifier, the indicator should turn on within
6–8 months. You may not need to replace
your filter yet, but you should check it when
turns on.
Check Filter Indicator
Cleaning the Air Purifier
1. Unplug before cleaning.
2. Wipe the outside of the air purifier with a
soft, dry cloth. If necessary, wipe the housing
with a damp cloth, then immediately dry.
3. Vacuum the inside of the air purifier.
Filter When to Clean How to Clean When to Replace
Pre-Filter
Every 2–4
weeks
Use a soft brush or vacuum
hose [Figure 3.1]
6–8 months
True HEPA
& Activated
Carbon Filter
Do not clean
The outer pre-filter should be cleaned
every 2–4 weeks to increase the eciency
and extend the life of your filter. Clean the
pre-filter using a soft brush or vacuum hose
to remove hair, dust, and large particles.
[Figure 3.1]
Do not clean the filter with water
or other liquids.
Cleaning the Filter
Note: Do not clean with abrasive chemicals
or flammable cleaning agents.
Note: Do not clean the True HEPA and
Activated Carbon Filters.
To Next Page
Loading...
Need help?
General
