Levoit Core 200S - CARE & MAINTENANCE; Cleaning and Filter Replacement

12
Note: You can also reset the Check Filter
Indicator in the VeSync app.
Note: When your air purifier is set up with
the VeSync app, you can also check the app
to see your remaining filter life. You will also
receive a notification from VeSync when it’s
time to check your filter.
Resetting the Check Filter
Indicator
Reset the Check Filter Indicator when:
A.
lights up red.
1. Replace the filter (see page 13).
2. Turn on the air purifier.
3. Press and hold
for 3 seconds.
will blink 3 times and turn o
once successfully reset.
B. The filter was changed before
lit up.
3. Press and hold
for 3 seconds.
will blink 3 times and turn o
once successfully reset.
will light up as a reminder to check the
filter. Depending on how often you use the
air purifier, the indicator should turn on within
6–8 months. You may not need to replace
your filter yet, but you should check it when
turns on.
Check Filter Indicator
The outer pre-filter should be cleaned
every 2–4 weeks to increase eciency
and extend the life of your filter. Clean the
pre-filter using a soft brush or vacuum hose
to remove hair, dust, and large particles.
Do not clean the filter with water or other
liquids. [Figure 3.1]
Cleaning the Filter
CARE & MAINTENANCE
Cleaning the Smart Air Purifier
• Unplug before cleaning.
• Wipe the outside of the air purifier with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
• Vacuum the inside of the air purifier.
• Do not clean with abrasive chemicals or
flammable cleaning agents.
Filter When to Clean How to Clean When to Replace
Nylon Pre-Filter Every 2–4 weeks
Use a soft brush or
vacuum hose [Figure 3.1]
6–8 months
True HEPA & High-Eciency
Activated Carbon Filters
Do not clean
Figure 3.1