10
Cleaning the Filters
Cleaning the Wheel Axles
Cleaning the Roller Brush
To clean the disc filter, rinse with water and
allow to dry completely before replacing
inside the dust bin. The disc filter should be
cleaned once a month.
To clean the cup filter, pull out any hair or
pet fur trapped in the cup. Then, replace
inside the dust bin. The cup filter should be
cleaned every 2–3 uses.
Use the cleaning brush to remove any dirt
or trapped hair from the wheel axles. If
necessary, carefully cut away any tangled
hair with scissors or a sharp knife.
Periodically clean the roller brush to avoid
blockage or jamming.
1. Turn the vacuum o. Detach the vacuum
head from the stick by pressing the
vacuum head release button.
2. Use a coin to unlock the roller brush by
turning the brush lock counterclockwise
until the slot is vertical. Pull the roller
brush out [Figure 4.1].
3. Carefully use a pair of scissors or a
sharp knife to remove any hair tangled
around the roller brush.
4. Replace the roller brush and use the
coin to turn the brush lock clockwise
until the slot is horizontal.
Note:
• The disc filter should be replaced
every 6–8 months.
• To maintain the performance of
your vacuum, only use ocial
Levoit filters. To buy replacement
filters, visit Levoit’s online store. Go
to levoit.com for more information.
Figure 4.1
To Next Page
Loading...
Need help?
General
