14
CARE & MAINTENANCE (CONT.)
To maintain the performance of your filters,
they should be routinely washed and replaced.
• The pre-filter should be washed once
a month and replaced after 6 months.
• The main filter should be washed
once every 6 months and replaced
after 1 year.
Cleaning the HEPA-Type Filters
Replacement Filters: To maintain the
performance of your vacuum, only use ocial
Levoit filters. For more information, contact
Customer Support (see page 19).
HEPA-Type Pre-Filter
1. Pull up on the pre-filter housing to
remove it from the top of the vacuum
body [Figure 3.4].
HEPA-Type Main Filter
1. Rotate the main filter housing
counterclockwise to remove it from
the back end of the vacuum body
[Figure 3.6].
2. Rotate the pre-filter counterclockwise
to remove it from the housing
[Figure 3.5].
Figure 3.4
Figure 3.6
Figure 3.7
Figure 3.5
3. Gently tap the pre-filter over a trash
can to remove dust and debris.
4. If necessary, run the pre-filter under
running water to wash it. Allow it to
dry for 24 hours before reinstallation.
2. Rotate the main filter
counterclockwise to remove it from
the housing [Figure 3.7].
3. Gently tap the main filter over a trash
can to remove dust and debris.
4. If necessary, run the main filter under
running water to wash it. Allow it to
dry for 24 hours before reinstallation.
To Next Page
Loading...
