TURNING THE CAMERA ON AND OFF
Press the Power button (8) for about 3 seconds to turn the camera on. The
camera will sound a beep to conrm that it is ready for use. Press and hold
Power button (8) for about 3 seconds again to turn it off.
Note: The camera will auto power off after 60 seconds of inactivity.
SELECTING THE PHOTO RESOLUTION
There are 2 resolution modes:
High resolution: the camera can store about 48 pictures in this mode.
Low resolution: the camera can store about 186 pictures in this
mode.
1. Press the Menu button (8) three times to see what kind of resolution setting is
selected on your camera.
2. Press the Shutter button (1) once within 3 seconds to change the resolution.
3. Repeat steps 1 and 2 to modify the resolution again.
FLASH FUNCTION
Switch on the camera.
A Auto Flash
1. Press the Menu button (8) until the A icon appears on the lower left
the window and go back to the installation
menu. Now you can install the camera
driver.
2. Click “Install Driver”, and then follow the
instructions to install the camera driver.
3. You will need to reboot your computer
after the driver installation. The “Dual
Mode Camera” driver allows you to use
your digital camera as a webcam.
Note:
• If the CD does not auto run, click “Start”, “Run”, then type in “D:\autorun.
exe” in the Run dialog text box (where D:\ is your CD-ROM drive) and press
Enter.
• You must install the driver before downloading pictures/videos from the
camera or using it as a webcam.
• Make sure the camera is not connected to your computer before installing
the driver and the software.
• When launching the “PhoTags Express” software for the rst time, a
registration dialog box is displayed on-screen. You can choose to register the
program, skip the registration process or to stop displaying this dialog
box again.
To Next Page
Loading...
Need help?
General
