TAKING PHOTOS (Camera Mode)
FLASH FUNCTION
SELF-TIMER (CAMERA MODE ONLY)
SELECTING THE PHOTO RESOLUTION
SELECTING THE IMAGE QUALITY
Single shooting
You are already in “Single shooting” mode when you switch on the camera (the
icon is displayed on screen). Press the Shutter key to take a photo. The number of
pictures that you can take in memory is shown on the LCD screen.
Continuous shooting
1. When you are in “Single shooting” mode, press the “Power/Menu” button once.
2. Then press the “Down” button once. The “Continuous shooting” mode icon is
displayed on the screen.
3. Press the Shutter key to take 3 pictures continuously.
4. The camera automatically goes back to “Single shooting” mode. Follow steps 1 to
3 to enter “Continuous shooting” mode again.
Note: To use the ash in “Continuous shooting” mode, please activate the ash rst
by pressing the “Down” button once, then follow steps 2 to 3.
Press the “Down” button once to turn the ash on. Press “Down” button again to turn
ash off.
1. In camera mode, set the resolution size to 1.2M (see section “Selecting the Photo
Resolution”.)
2. Press the “Up” button repeatedly until you nd a frame you like.
3. Press the shutter button to conrm and take a picture.
Note: The photo frame function cannot be used in video mode and other resolutions.
1. Press the “Power/Menu” button once. The “Self-timer” icon is displayed on
screen.
2. Press the “Shutter” button to start the 10-second countdown and take a photo.
3. The camera automatically goes back to “Single shooting” mode . Follow steps
1 to 2 to enter “Self-timer” mode again.
1. Press the “Power/Menu” button once, then use the “Down” button to select the
“Resolution” icon .
2. Press the Shutter key repeatedly to select the desired resolution.
There are 3 resolution modes:
High resolution (5M) / Medium resolution (3M) / Low resolution (1.2M)
3. Press the “Power/Menu” to go back to camera mode.
1. Press the “Power/Menu” button once, then use the “Down” button to select the
“Image quality” icon .
2. Press the Shutter key repeatedly to select the desired image quality.
There are 2 levels of quality:
High quality. / Low quality.
3. Press the “Power/Menu” button to go back to camera mode.
SELECTING THE LIGHT SOURCE FREQUENCY
1. Press the “Power/Menu” button once, then use the “Down” button to select the
“Frequency” icon “Hz”.
2. Press the Shutter key repeatedly to select the desired frequency: “50HZ” or “60HZ”.
3. Press the “Power/Menu” to go back to camera mode.
CAPTURING VIDEO CLIPS (Video Mode)
1. Press the “Mode” button repeatedly until the video icon is displayed on
screen.
2. Press the Shutter key to start shooting videos. The recording length is displayed
on the LCD screen.
3. Press the Shutter key again to stop recording and automatically save the video in
AVI format.
4. To go back to “Single shooting” mode, press the “Mode” button repeatedly until the
icon is displayed on screen.
Note:
• To use the ash in “video mode”, please activate the ash rst by pressing the
“Down” button once, then follow steps 2 to 3.
• You can use Media player and Quick time (not included on the software CD to play
AVI les on your computer.
DJ134seriesIM1474_17Nov_V02.indb 12
To Next Page
Loading...
Need help?
General
