What to do if there is no audio from my Lexicon CP-3?
If your Lexicon Processor has no audio, ensure that the CP-3 VOLUME is set above -54dB. Verify that you've selected the correct input. Also, check the input and output connections, ensuring they aren't reversed relative to the IN and OUT jacks of your receiver, amplifier, or preamp.
How to troubleshoot a Lexicon Processor that won't turn on?
If your Lexicon Processor's power does not come on, check the line cord to ensure it's properly connected to both the AC outlet and the receptacle on the CP-3 rear panel. Also, verify that the power switch on the CP-3 rear panel is in the ON position.
Why is my Lexicon Processor remote control not working?
If your Lexicon Processor remote control isn't working, first check the batteries to ensure they are correctly inserted with the proper polarity. Then, make sure that nothing is obstructing the infrared sensor on the CP-3 front panel. Try using the other remote. If neither remote works, the issue is internal.
How to fix a Lexicon Processor with no output?
If there is no output from your Lexicon Processor, start by checking the Input Level meters to make sure signal is coming into the CP-3. Increase the VOLUME using the remote control, and check the Front/Back and Left/Right BALANCE. Also, check the CP-3 MUTE controls to ensure they are not engaged.
What does 'wrong remote' mean on my Lexicon CP-3 Processor?
If you see a "Wrong remote" message on your Lexicon Processor, the CP-3 remembers which remote (Standard or Expanded) was last used to turn it on. To resolve this, turn the CP-3 off and then back on using the remote you wish to use.
How to fix Lexicon CP-3 input level meters not working?
If the input level meters on your Lexicon Processor are not functioning, make sure that 'LEVEL METERS' in the DISPLAY ADJUST sub menu of the Setup menu is turned ON.
How to stop Lexicon CP-3 Processor from interfering with TV?
If you are experiencing interference with AM, FM, TV, or Cable TV when using your Lexicon Processor, and Cable TV is connected to any component in the system, begin by completely unplugging the Cable.
Why does my Lexicon CP-3 Processor center channel sound muffled?
If the center channel only plays muffled sound in the left and right channels on your Lexicon Processor, and speakers are added to or removed from your system, the Speaker Configuration menu must be altered accordingly.
What to do if my Lexicon CP-3 behaves erratically?
If your Lexicon Processor is behaving erratically, perform the Restore Defaults procedure as described in the manual.
Why is there clicking in the audio of my Lexicon CP-3?
If you hear clicking in the audio from your Lexicon Processor, it could be an artifact of the CP-3's S/N Optimization system. To prevent this, turn OFF the S/N Optimizer for each input; however, be aware that defeating it will result in an increase in background noise.
Guidelines and procedures for connecting the CP-3 to other audio-visual components.
Procedures for calibrating the CP-3 to optimize sound performance based on the listening environment.
How to lock system settings to prevent accidental changes, ensuring system integrity.
Explanation of how to select and engage the CP-3's primary operating modes.
Overview of the Surround modes, including Television, Music, and THX Cinema.
Explanation of Pro Logic mode for Dolby Pro Logic surround decoding.
Guide to using THX Cinema mode for an immersive film audio experience.
A reproduction of the Setup menu options for recording calibration values.
To Next Page
General