Bank 7: the Sampler Programs
6-11
REVERSE TIME (Mono Forward/Reverse)
REVERSE TIME sets how much of the sample to play
back (in reverse play).
TAIL TRIM
Once a sample has been recorded, TAIL TRIM is used
to remove unwanted information at the end of the
sample, and select the start point for reverse playback.
A fine mode is provided for precise trim. Press the
button under the Head Trim slider until the display
flashes. To exit, press the button again and hold it until
the display stops flashing.
TLV, Play TRIGGER
Play Trigger selects the method for triggering play-
back. With the control all the way down, playback is
continuous. In the middle range are playback trigger
levels corresponding to the Headroom display on the
LARC. With the slider all the way up, triggering is
manual only, via the PLAY key.
After selecting a play trigger method or level, enter the
selection by pressing PLAY.
VX, Record VOICE MODE
In the Dual Rate Change Sampler, RECORD VOICE
selects which of the two voices to record.
To Next Page
Loading...
