EasyManua.ls Logo

Lexicon LEXICON480LV4 - Page 86

Lexicon LEXICON480LV4
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-8
Lexicon 480L Owner's Manual
Page Two
FR-1 L and FR-1R
These controls allow frequency settings to be adjusted
independently on either the left or the right channel.
Frequency settings fall between 30 Hz and 17 kHz.
Q
Q adjusts the amount of bandwidth affected by the level
control. The Q is determined by dividing the center
frequency by the bandwidth to be affected (in Hz.). For
example, if a frequency of 1000 Hz is selected, and the
bandwidth to be boosted or cut is 500 Hz, the Q = 2. The
Page Two filters provide a Q adjustment from shelf to
Notch ( Q =16 or Q =32). The Shelf (SL) on Page Two
filters is a low frequency shelf. This means that with a
frequency of 500 Hz, a level of +12 dB, and Shelf (SL)
selected, frequencies below approximately 300 Hz will
be boosted by 12 dB, and 500 Hz will be boosted
approximately +9 dB. The Notch feature is found only
on the Page Two filters and is optimized for low
frequencies.
LEV
LEV provides level boost or cut at the defined fre-
quency and Q settings. LVL is adjustable between -12
to +12 dB when the Q setting falls between shelf and Q
= 7. When a Notch Q is selected (Q=16 or Q=32), LVL
is adjustable between -36 and +36 dB. This only
applies to the Page Two filters.
Page Three
FR-1 L and FR-1R
These controls allow frequency settings to be inde-
pendently adjusted on either the left or the right chan-
nel. Frequency settings fall between 30 Hz and 17 kHz.
Q
Q adjusts the amount of bandwidth affected by the level
control. The Q is determined by dividing the center
frequency in Hz by the bandwidth to be affected in Hz.
For example, if a frequency of 1000 Hz is selected, and
the bandwidth to be boosted or cut is 500 Hz, the Q =
2. The Page Three filters provide a Q adjustment from
shelf to Q = 7. The filters on Page Three have a high
frequency shelf that boosts all frequencies above the
set frequency. This is identified by SH” in the Q
display.
LEV
LEV provides level boost or cut at the defined fre-
quency and Q settings. LVL is adjustable between -12
to +12 db.

Table of Contents

Related product manuals