Lexicon MC-12 - Page 56

Lexicon
MC-12 Serial Communications Protocol Printed on: 07/13/05
Host Commands:
DC_CMD_RESET 0x10
HOST_WAKEUP 0x11
HOST_SLEEP 0x12
DC_CMD_RESTORE_DEFAULTS 0x13
DC_CMD_IR 0x14
DC_CMD_GET_CONFIG 0x15
DC_CMD_GET_SYS_STATUS 0x16
DC_CMD_GET_REC_STATUS 0x17
DC_CMD_GET_SYS_PARAM_BY_ID 0x18
DC_CMD_GET_SYS_PARAM_BY_NAME 0x19
DC_CMD_GET_SYS_PARAM_VALUES 0x1A
DC_CMD_GET_EFFECT 0x1B
DC_CMD_GET_EFFECT_PARAM_DEF 0x1C
DC_CMD_GET_EFFECT_PARAM_VALUES 0x1D
DC_CMD_SET_SYS_PARAM_VALUES 0x1E
DC_CMD_SET_EFFECT_PARAM_VALUES 0x1F
DC_CMD_SET_EFFECT_NAME 0x20
DC_CMD_SET_SYS_VOLUME 0x21
DC_CMD_SET_SYS_BALANCE 0x22
DC_CMD_SET_FRONT_BACK_BALANCE 0x23
DC_CMD_SET_EFFECT 0x24
DC_CMD_SET_REC_INPUT 0x25
DC_CMD_CLEAR_REC_INPUT 0x26
DC_CMD_SET_ZONE2_VOLUME 0x27
DC_CMD_SET_ZONE2_BALANCE 0x28
DC_CMD_GET_FPD_CTRL 0x29
DC_CMD_SET_FPD_CTRL 0x2A
DC_CMD_GET_CUST_NAME 0x2B
DC_CMD_SET_CUST_NAME 0x2C
DC_CMD_GET_INPUT_NAME 0x2D
DC_CMD_SET_INPUT_NAME 0x2E
DC_CMD_GET_COM_CONFIG 0x2F
DC_CMD_SET_COM_CONFIG 0x30
DC_CMD_SET_MUTE 0x31
DC_CMD_SET_OUTPUT_ADJ 0x32
DC_CMD_SEND_DISPLAY_STR 0x33
MC_CMD_GET_SYS_PARAM_BY_ID 0x35
MC_CMD_SET_SYS_PARAM_VALUE_BY_ID 0x36
MC_CMD_SET_SYS_PARAM_VALUE_BY_ID_NO_RUN 0x37
MC_CMD_GET_CONFIG 0x38
MC_CMD_IR 0x39
© 2005 Harman Specialty Group All rights reserved. 56 of 106