Lexicon MC-12 - Page 9

Lexicon
MC-12 Serial Communications Protocol Printed on: 07/13/05
command/responses/notifications packets have been implemented exactly as they were in the MC-1. These
commands may not fully exercise the functionality of the MC-12 (i.e. Mc-1 has 8 inputs that have been
mapped to 8 of the 12 inputs on the MC-12, MC-1 IR codes are not the same as MC-12 IR codes) In the
case of these commands additional MC-12 commands have been added to fully implement the MC-12
functionality. In addition, some the internal structure of the MC-12 has forced the protocol to be unable to
support some MC-1 commands. These commands have been totally replaced with new commands that
provide more control over the MC-12 than was capable in the MC-1. (Parameter Set/Get commands)
© 2005 Harman Specialty Group All rights reserved. 9 of 106