Hardware & Software Upgrade Instructions Lexicon
2-6
When upgrading from previous versions, it can take the MC-8
as long as ten minutes to initialize and complete its diagnostic
procedure on the first restart.
Note:
It is only on the very first restart after upgrading from previous
versions that the MC-8 takes an extended period of time to initialize
and complete its diagnostic procedure.
12. The message “Update and restoration of original configuration was
successful” displays in the Updater window. Click
Exit to exit the
updater.
Note:
If you elected to Skip Config Save, the MC-8 is now configured with
factory-default settings. Otherwise, the pre-upgrade configuration
settings have been restored.
13. Power off the MC-8 with the rear panel power switch. Then,
disconnect the serial extension cable from the MC-8 and the
computer.
14. Power the MC-8 back on.
To Next Page
Loading...
Need help?
General
