through the Main Mix Bus, just as you would any audio or plug-in effect.
USING THE MX400 PLUG-IN WINDOW
In your DAW, open the Lexicon MX400 plug-in. You’ll see an instance of the Program
Editor window. You can use the MX400 plug-in software just as you would any other
plug-in: Session Recall, automation – everything behaves just as any other VST
TM
or
Audio Unit plug-in. The primary difference is that the audio processing occurs in the
MX400 rather than on your computer. And, since the MX400 is a physical device, you
can only open one instance (per physical device) of the plug-in window. If you attempt
to open more than one plug-in window, the message shown below will appear.
This message will also appear if the MX400's MIDI ports are being used by the DAW or
another application.
CONTROLS
The MX400’s Plug-In window functions much like the MX-Edit Program Editor win-
dow described on page 38.
44
Using the MX400 as a Hardware Plug-In
To Next Page
Loading...
