Lexicon PCM 42 - 6.4 Power and Dimensions

Modulation Controls
Manual VCO-Sweep: Sets sampling rate.
Depth: Sets amount of internai delay sweep.
Waveform: Sets mix of modulation waveforms
Rate: Sets frequency of internal low frequency
oscillator.
Headroom Indicator
5 LEDs display input in 6-dB steps. 0 dB” is the point
t which the input ts limited.
oO
Bypass Indicator
Single LED, indicates the unit has been placed in the
bypass state from the rear panel.
Clock Indicator
Single LED, flashes in time with clock output.
6 kHz Indicator
Single LED, indicates unit is in extended delay mode.
Infinity Indicator
Single LED, indicates that an audio segment is
trapped in delay memory.
Rate Indicator
Single LED, flashes in time with LFO output.
6.4 POWER AND DIMENSIONS
AC Requirements
115 or 230 volts (selectable), 50-60 Hz, 20 watts max-
imum. Standard |EC power connector on rear of unit;
3-prong cord provided.
Protection
Mains are fused (standard U.S. 3AG fuses).
Export Models — Mains and secondaries are fused
(European 20mm fuses). An RFI power line is also in-
stalled. NOTE: a 100-Volt export model is available on
special order.
Dimensions
Standard 19” relay rack mount (483 mm). 13/4” high
(44mm) by 11” deep (280 mm).
Weight
Net 5.5 Ibs (2.5 kg); shipping 8 Ibs. (3.6 kg).