Lexicon PCM 42 - Page 8

n onan 41) or any potentiometer, the
o the ee remotely. it can
uxillary input which is combined
without gain conte (nominal line
ions 3.3 and 4.2.2
A ss main |
= =
ae)
eS
See Secti
NOTE: THIS FUNCTION IS INDEPENDENT OF THE
F ai NT PANEL FEEDBACK CONTROL. RUNAWAY
DBACK CAN RESULT IF BOTH CONTROLS ARE
RAISED AT THE SAME TIME.
K. MIX CONTROL JACK
Like the FEEDBACK CONTROL, the MIX CONTROL
jack { ai 35 dual functions. With a potentiometer o
foot pedal, the user can raise and lower the volume
the delayed signal in the MAIN OUTPUT mix. ae
delay effects can be faded in and out at will. This jack
can also be used to inject an external signal into the out-
put mix. (See Sections 3.3 and 4.2.2.)
L. MAIN OUTPUT
The MAIN OUTPUT is an unbalanced tip/sleeve jack
whose signal level is determined by the adjacent con-
trol. It carries the blend of di rect and processed signal
which is set with the front panel OUTPUT MIX control
(Fig. 2.1, I).
f
M. OUTPUT LEVEL
The OUTPUT LEVEL control adjusts the MAIN OUT-
PUT level from its maximum of +179 dBV (9 V rms)
down to full attenuation. This control should be ad-
justed to provide the maximum level to the monitor
system, amplifier or console without clipping its input
stage.