2-34
Basic Operation
Lexicon
Patch 2 ✱ Src
Int LFO1
The asterisk (
✱
) indicates that LFO1 Rate will be altered when you turn
ADJUST. Press Load/✱ to change the selection to the other LFO1 parameters
(Shape, P Width, and Depth).
■ Mod : LFO1 ✱ Rate
5.0 0.00Hz
PATCHING (continued)
Creating a Patch with Default Values
(continued)
The ADJUST knob will now scroll through all of the available
parameters of Deep Blue. The lower line of the display will show
the edit matrix row label on the left, and the parameters in that
row on the right. Turn ADJUST clockwise until Out Width (in the
effect's Controls row) is displayed in the lower right corner.
That’s all there is to setting up a default patch— select a Source and
Destination, and the minimum and maximum patch values are set
automatically.
Of course, you will often want to modify the patch further, either
by adjusting the modulation source parameters, changing the
default values or adding additional pivot points. In the following
sections, we’ll continue using this patch to demonstrate examples
of these modifications. When we’re done, the new patch will add
dynamic spatialization to the Deep Blue program.
Adjusting the Modulation Source Parameters
Continuing the previous example, we’ll adjust the rate of LFO1 by
jumping to it from the Patch row.
Press Load/✱ repeatedly to return to the Patch 2 Source selection
display.
Patch 2 ✱ Dst
Controls Out Width
Patch 2 Values
✱ 000 -360 Mono
Patch 2 Values
✱ 127 +360 Mono
The Out Width parameter is now assigned as the patch
Destination.
Now, press Load/✱ to bring up the Values display. This will show
the default Destination value setting (-360 Mono). This is the value
assigned to Out Width when LFO1 is at its minimum value (000).
Turn ADJUST one click counterclockwise to display the default
Destination value (+360 Mono) assigned to Out Width when LFO1
is at its maximum value (127).
Press Edit to jump directly to the LFO1 parameters in the Mod row.
To Next Page
Loading...
