2-35
Basic Operation
PCM 91
The display now shows position 5.0 in the Edit matrix Mod Row.
Turn ADJUST to change the rate of LFO1 to 0.30Hz.
Notice that the ✱ is to the left of the Source value. This indicates
that the Source value is selected and its value will be changed when
you turn ADJUST.
Now, press Edit to jump back to your previous position in the Patch
row.
Changing the Default Destination Values
Let’s modify the patch further by adjusting the Destination values
to a more useful range.
Press Load/✱ repeatedly until the Patch 2 Values screen is
displayed.
Mod : LFO1 ✱ Rate
5.0 0.30Hz
Patch 2 ✱ Src
Int LFO1
Press Load/✱ once to move the ✱ to the right of the Source value.
When the ✱ is in this position, ADJUST will change the Destination
value.
Patch 2 Values
✱ 000 -360 Mono
With the Destination value selected, turn ADJUST clockwise to set
the value to +0.
The asterisk (✱) indicates that the Source
value will be altered when you turn
ADJUST.
Press Load/✱ to move the asterisk to this
position, where it indicates that
Destination values will be altered when
you turn ADJUST.
Patch 2 Values
✱ 000: -360 MONO
Patch 2 Values
000: ✱ -360 MONO
Patch 2 Values
000 : ✱ +0 Mono
Patch 2 Values
127 : ✱ +360 Mono
Next, we’ll want to adjust the Destination value when LFO1 is at its
maximum value. One way to do this is to press Load/✱ three
times to cycle the ✱ to the display of the Source value, and
continue on from there — but we’ve provided a short cut! Press
Edit to jump to the next assigned value ( in our example, the
maximum value for LFO1).
To Next Page
Loading...
