Need help?Do you have a question about the Lexicon PCM 80 and is the answer not in the manual?
General| Type | Digital Effects Processor |
|---|---|
| Sampling Rate | 44.1 kHz |
| MIDI | In, Out, Thru |
| Control | Front panel, MIDI |
| Display | LCD |
| Effects | Reverb, Delay, Modulation, Pitch Shift |
| Frequency Response | 20 Hz - 20 kHz |
| Dynamic Range | 90 dB |
| Inputs | 2 x XLR, 2 x 1/4" TRS |
| Outputs | 2 x XLR, 2 x 1/4" TRS |
| Total Harmonic Distortion | <0.01% |
| Signal to Noise Ratio | >90 dB |
| Dimensions | 19" x 1.75" x 12" |
| Power Supply | 50-60 Hz |
Overview of the 200 preset programs organized into 4 banks for a wide range of applications.
Details on the ten stereo algorithms used to create effects, divided into 4-Voice and 6-Voice classes.
Description of the front panel controls, display, and ease of use for programming and editing.
A visual representation of the PCM 80's internal signal flow and component connections.
Detailed explanation of each control and button on the PCM 80's front panel interface.
Description of all input, output, and control connectors located on the rear panel.
Guidance on mounting, power requirements, and connecting audio and control interfaces.
Instructions for properly setting analog and digital input/output levels and understanding headroom.
Information on using PCMCIA SRAM cards for storing registers, setups, and system configurations.
Explanation of the five fundamental operating modes: Program Banks, Register Banks, Edit, Control, and Tempo.
How to navigate the parameter matrix using SELECT, Up, Down, and ADJUST controls.
Detailed description of system, audio, MIDI, and setup parameters accessible via Control Mode.
How to set and control tempo using internal, MIDI, or Tap sources for rhythmic effects.
Guide to editing effects via the Soft Knob, Go mode, Pro mode, and the full edit matrix.
How to assign sources (controllers) to destinations (parameters) to create custom control patches.
Overview of the ten stereo effects algorithms, categorized into 4-Voice and 6-Voice types.
Detailed descriptions of Concert Hall, Plate, Chamber, Inverse, and Infinite algorithms and their parameters.
Details on Glide>Hall, Chorus+Rvb, M-Band+Rvb, Res1>Plate, and Res2>Plate algorithms.
Alphabetical listing and explanation of all PCM 80 parameters organized by row label.
Detailed descriptions for presets in Program Bank 0, covering Multi Effects.
Descriptions for Rhythmic Echo, Delay, and Ambience Effects presets in Program Bank 1.
Details on EQ, Spatial, and Gain Effects presets found in Program Bank 2.
Descriptions for Reverb, Processed Reverb, and Remix Effects presets in Program Bank 3.
An alphabetical listing of all presets with their corresponding bank and matrix location.
How to set the PCM 80 to receive MIDI messages on a specific channel.
Controlling tempo rate using MIDI Clock, and using the PCM 80 as a MIDI Clock source.
How to load registers using MIDI Program Change messages and control parameters via Dynamic MIDI.
Information on MIDI controller message ranges and potential compatibility issues.
How the PCM 80 interprets Program Change and Bank Select messages for loading presets.
How to dump effect data, banks, maps, and setups directly from the PCM 80.
Troubleshooting steps for MIDI Program Change and SysEx command issues.
Solutions for issues like digital signal lock, no digital output, or no effects output.
Procedure to restore all system parameters to their original factory default settings.
How to return the PCM 80 to its factory state, erasing all registers and setups.
Details on connectors, impedance, dynamic range, and levels for audio inputs.
Details on connectors, impedance, dynamic range, and levels for audio outputs.
Technical specifications for Analog-to-Digital and Digital-to-Analog conversion performance.
Information on digital audio connectors, format, sample rates, and data paths.
Specifications for MIDI, Footswitch, and Foot Controller interfaces.
Overall physical dimensions, weight, power requirements, and environmental operating conditions.
To Next Page
