Lexicon PCM 80 - Table of Contents

Contents
Introduction
1. Product Overview
Block Diagram .................................................................................... 1-1
Front Panel Overview ......................................................................... 1-2
Rear Panel Overview.......................................................................... 1-3
Installation Notes ................................................................................ 1-4
Mounting ...................................................................................... 1-4
Power Requirements.................................................................... 1-4
Audio Connections ....................................................................... 1-4
Control Connections..................................................................... 1-4
Setting Audio Levels .................................................................... 1-5
Headroom Display • Overload • Setting Analog and Digital
Input Level • Setting Output Level
Configurations .............................................................................. 1-7
Memory Cards.............................................................................. 1-8
Memory Expansion ...................................................................... 1-8
2. Basic Operation
Modes of Operation ............................................................................ 2-1
Navigating a Matrix ...................................................................... 2-2
Info ............................................................................................... 2-3
Control Mode ...................................................................................... 2-4
Program and Register Banks ........................................................... 2-17
Tempo Mode .................................................................................... 2-19
Editing an Effect ............................................................................... 2-22
The Soft Knob ............................................................................ 2-22
The Soft Row ............................................................................. 2-23
Compare .................................................................................... 2-24
Bypass ....................................................................................... 2-24
Store operations ......................................................................... 2-25
Turning Memory Protection Off • Storing an Effect
Renaming the Effect • Renaming the ADJUST Knob Patch
Selecting a Bank and Register Location
The Full Edit Matrix .................................................................... 2-27
Creating a Soft Row
Patching ..................................................................................... 2-30
About Sources • The Patch Row • Assigning a Source
Patch Sources • Assigning a Destination • Assigning
Values • Jump • Patching Examples • Multiple Patches
with the Same Destination • Mod Row Patching