Possible Test
Tone Settings
Default Test
Tone Setting
Possible
Gain Settings
Default
Gain Setting
Parameter
Setup Menus
Lexicon
3-22
Before output level calibration begins:
• It is recommended to use a Sound Pressure Level (SPL) meter
to calibrate variable output levels. An SPL meter is a device that
measures the relative loudness of each speaker to ensure
accurate output level calibration. SPL meters are available at
Radio Shack (catalog no. 33-2050).
Note:
RT-10 variable output levels do not need to be
configured when the RT-10 is connected to an
associated component such as the MC-12 or MC-8
Digital Controller, which allows output levels to be
calibrated for analog audio sources.
• -6.0 to +6.0dBL/R
0.0dB `
• Auto
•On
•Off
Off
• -6.0 to +6.0dBC
0.0dB `
• Auto
•On
•Off
Off
• -6.0 to +6.0dBLS
0.0dB `
• Auto
•On
•Off
Off
• -6.0 to +6.0dBRS
0.0dB `
• Auto
•On
•Off
Off
• -6.0 to +6.0dBSW
0.0dB `
• Auto
•On
•Off
Off
` These settings are recommended when the RT-10 is connected to an MC-12 or MC-8 Digital Controller. When no setting is indicated, any setting
can be selected.
Audio2 (continued from page 3-21)
To Next Page
Loading...