LEXIN SMART PUMP P5 - Troubleshooting

09
Exclusion Approach
Tighten the trachea.
Problems
Inflate too slow
Unable to inflate
Unable to increase or decrease
the preset pressure value
Inflates properly but pressure
value shows zero
After tightening the air valve,
the air pump has automatically
shut down
There is a leak when
connecting the trachea
The power indicator does
not light up after charging
Troubleshooting
1. Check whether the power is sufficient.
2. Check whether the air tube leak gas.
3. Check whether the connections at both
ends of the trachea are tightened.
4. Check whether the inflated item leak gas.
1. Check whether the power is sufficient.
2. Check if the current tire pressure is higher
than the preset value.
Check if the pump is in correct inflation
mode, select the custom mode to adjust
the preset value in the range of 3-150 Psi.
1. Low pressure products such as balloons
are not within the measurable range of the
device.
2. In the case of an empty tire, it takes a
short time of inflating to display the tire
pressure value.
It will automatically shut down after 3
minutes, long press the power button to
turn it on again.
The lithium battery has a significant voltage
drop during the discharge process, which
leads to the phenomenon that the color of
the indicator light in charging state and the
standby state are inconsistent, this
phenomenon is not a fault.
Replace a safe and compliant charging cable
and adapter to recharge it.
The color of the power
indicator light in inflating
state is inconsistent
with that in the standby state
LX-SMART PUMP P5 USER GUIDE