192
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN
4. OPERATION
Warning:Do not use the charger outdoors or expose it to wet or damp conditions. Water
entering the charger will increase the risk of electric shock.
Warning: Explosive gases. Prevent Flames and sparkles. Provide adequate ventilation during
charging.
HOW TO USE THE CHARGER
There are two positions can operate the charger:
1) Horizontal: Put the charger on a table horizontally and make it stabilize.
2) Vertical : Install two nails on a wall vertically , put the charger on the two nails xedly.
Note: The charger has hanging hols for convenient storage.Install screws in the wall 90mm apart. Use
screws suciently strong to hold the combined weight of the charger, and the distance between the head
of nail and the wall is 8 mm.
HOW TO CHARGE THE BATTERY PACK
NOTICE: Lithium-ion battery pack is shipped partially charged. Before using it the first time,
fully charge the battery pack.
1) Align the battery pack with the mounting slots into the charger, slide the battery pack down onto the
charger.
2) Plug the charger into an appropriate outlet. The light indicator will turn to be green light ashing to
indicate the charging process has started.
3) When charging is completed, the light will turn to green. The battery pack is now fully charged, unplug
the charger and remove the battery pack.
Note: If plug the charger into an appropriate outlet only, the light indicator will be red.When charging, it
is important to provide adequate ventilation to avoid this battery pack becomes damaged. The available
temperature of the charger is between +4°C and 24°C during operation.
WARNING: When battery charge runs out after continuously use or exposure to direct sunlight or heat,
allow time for the tool to cool down before re-charging to achieve the full charge.
To Next Page
Loading...
Need help?
General