EasyManuals Logo

Lexmark C3224 User Manual

Lexmark C3224
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
Hibernate Mode
This product is designed with an ultralow power operating mode called Hibernate mode. When operating in
Hibernate Mode, all other systems and devices are powered down safely.
The Hibernate mode can be entered in any of the following methods:
Using the Hibernate Timeout
Using the Schedule Power modes
Factory default Hibernate Timeout for this product in all countries or regions 3 days
The amount of time the printer waits after a job is printed before it enters Hibernate mode can be modified
between one hour and one month.
O
mode
If this product has an o mode which still consumes a small amount of power, then to completely stop product
power consumption, disconnect the power supply cord from the electrical outlet.
Total energy usage
It is sometimes helpful to estimate the total product energy usage. Since power consumption claims are
provided in power units of Watts, the power consumption should be multiplied by the time the product spends
in each mode in order to calculate energy usage. The total product energy usage is the sum of each mode's
energy usage.
Regulatory notices for wireless products
This section contains regulatory information that applies only to wireless models.
If in doubt as to whether your model is a wireless model, go to
http://support.lexmark.com.
Modular component notice
Wireless models contain one of the following modular components:
Lexmark Regulatory Type/Model Number LEX-M08-001; FCC ID:IYLLEXM08001; IC:2376A-LEXM08001
Lexmark Regulatory Type/Model Number LEX-M07-001; FCC ID:IYLLEXM07001; IC:2376A-LEXM07001
To determine which modular components are installed in your particular product, refer to the labeling on your
actual product.
Exposure to radio frequency radiation
The radiated output power of this device is far below the radio frequency exposure limits of the FCC and other
regulatory agencies. A minimum separation of 20 cm (8 inches) must be maintained between the antenna and
any persons for this device to satisfy the RF exposure requirements of the FCC and other regulatory agencies.
Notices 146

Table of Contents

Other manuals for Lexmark C3224

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lexmark C3224 and is the answer not in the manual?

Lexmark C3224 Specifications

General IconGeneral
Print TechnologyLaser
Print SpeedUp to 24 ppm
Memory256 MB
Input Capacity250 sheets
Output Capacity100 sheets
Duplex PrintingManual
Supported Operating SystemsWindows, Mac OS, Linux
Print Resolution600 x 600 dpi
Monthly Duty Cycle30, 000 pages
ConnectivityUSB, Ethernet
Maximum Paper Size8.5 x 14 inches
Weight30.9 lbs

Related product manuals