UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE TONER CARTRIDGEUNINET IMAGING INC. • BROTHER 1240/1650 • DISASSEMBLING THE TONER CARTRIDGE
LEXMARK E 250/350/450 DRUM UNIT REMANUFACTURING INSTRUCTIONS
REMANUFACTURING THE LEXMARK E250/350/450 DRUM UNIT
By Mike Josiah
3232 West El Segundo Blvd., Los Angeles, California 90250 USA • Ph +1 310 280 9620 • Fx +1 310 838 7294 • techsupport@uninetimaging.com • www.uninetimaging.com
© 2008 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
SU
MMIT
1. Remove the E-ring from the small gear side of the drum axle
shaft.
2. Remove the drum axle from the large gear side of the drum.
If you try to pull it out from the small gear side, the shaft will
jam up on the drum ground contact and damage the contact.
SUPPLIES REQUIRED
New replacement drum
New wiper blade
Cotton swabs
Isopropyl alcohol
Drum padding powder
TOOLS REQUIRED
Phillips head screw driver
Small common screw driver
Vacuum approved for toner
Needle nose pliers