UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE TONER CARTRIDGEUNINET IMAGING INC. • BROTHER 1240/1650 • DISASSEMBLING THE TONER CARTRIDGE
LEXMARK E 250/350/450 DRUM UNIT REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Los Angeles, California 90250 USA • Ph +1 310 280 9620 • Fx +1 310 838 7294 • techsupport@uninetimaging.com • www.uninetimaging.com
© 2008 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
SU
MMIT
RESETTING THE LEXMARK E350/352/450 MACHINES (DISPLAY)
1. With the printer off and the Press and hole the SELECT and BACK buttons, turn the printer on.
2. Press the right arrow until “RESET PC CNT” appears on the display.
3. Press the SELECT button. “=RESET” appears on the display.
4. Press SELECT again. “RESETTING PC CNT VALUE” appears on the display
5. Turn the printer off, and on. The counter is reset!
You can confirm the counter was reset by printing a “menu settings page”.
RESETTING THE LEXMARK E250 MACHINES (NON DISPLAY)
1. Turn off the printer.
2. Open the front cover.
3. Press and hold the Continue button (Big silver button with Diamond shape symbol) and turn the printer on.
4. Hold the button down until the last light (error light) is on solid, release the button and close the front cover.
5. When the cover is closed, all the top 3 lights should be on solid.
6. Press the cancel button (triangle symbol) 4 times very slowly until you see the toner low light (second light from
top) on solid.
7. Press the continue button and wait until you see the light sequence.
8. Press the cancel button and wait until you see the light sequence.
9. Finally power off the printer and power it back on to exit the configuration mode.
This resets the drum count on the printer (called the PC count by Lexmark).
PRINTING TEST PAGES E350/450 SERIES
1. Press the “Key” button on the control panel.
2. Press the “Down arrow” until REPORTS appears on the display.
3. Press the Select button.
4. Press the “Down Arrow” until the MENU SETTINGS PAGE, NETWORK SETUP PAGE, or PRINT FONTS appears on the
display.
PRINTING TEST PAGES E250 SERIES
1. Make sure the printer is READY.
2. Press the “Continue” button.
3. Both the menu settings page and the network setup page will print out.
CLEANING THE PRINTHEAD GLASS
Open the front cover and remove the toner and drum cartridges. Locate the glass printhead lens in a recess above
the cartridge bay. Wipe the glass down with a lint free dry cloth. Do NOT use any type of chemicals on the glass. Re-
install the cartridges and close the cover.
REPETITIVE DEFECT CHART
38.2mm PCR
47.8mm Developer Roller
51.7mm Transfer Roller
79.8mm Upper fuser Belt
95.5mm Lower fuser Roller
96.7mm OPC Drum
To Previous Page
Loading...
Need help?
General
Weight and Dimensions
