• Do not slide paper into the tray.
• To avoid paper jams, make sure that the stack height is below the maximum paper fill indicator.
• When loading letterhead, do either of the following:
One‑sided printing Two‑sided printing
• When loading prepunched paper, make sure that the holes on the long edge of the paper are against
the right side of the tray.
One‑sided printing Two‑sided printing
• Load envelopes with the
flap
side up and against the left side of the tray.
Warning—Potential Damage: Do not use envelopes with stamps, clasps, snaps, windows, coated
linings, or self‑stick adhesives.
5 Insert the tray.
6 From the control panel, set the paper size and paper type to match the paper loaded.
Loading paper and specialty media 30
To Next Page
Loading...
